AEG machines show codes like E10, E20, E30, E40, E50, E60, etc. Here's what these tell you—and simple solutions for most.
E10 / E11 / E12 – Water Fill ErrorWhat it means: The machine isn't filling with water properly—either due to low water pressure, blocked inlet hose, faulty valve, or trapped air
Quick fix:
- Check your tap is fully open, hoses aren't kinked, and inlet filters are clean.
- If issues persist, test the inlet valve with a multimeter (~2–4 kΩ)
What it means: Failure to drain water due to blockages in the filter, pump, or hose.
Fix:
- Clean the drain pump filter and hose.
- Make sure the hose isn't raised too high or kinked.
- Inspect and clean the sensor tubes or replace the pressostat if faulty.
- When unsure, call a tech.
Meaning: Door didn't lock/unlock or latch correctly. Could be overload, worn latch, or faulty lock sensor.
Fix:
- Check the door for obstructions and shut firmly.
- Inspect the latch and wiring; they may require replacement.
Meaning: Issues with motor performance—e.g., triac failure, tachometer faults, current imbalance.
Fix:
- Remove and inspect motor brushes.
- If suspect, call a trained engineer—fan belts, triacs, or motors may need replacing.
Meaning: Problems with heating elements, temperature sensors (NTC), wiring, relay, or leaks.
Fix:
- Check the heating element and wiring continuity.
- Replace the NTC sensor or element as needed—professional repair usually required.
Meaning: Sensor circuit issues, especially turbidity, weight sensor, or pump triac faults.
Fix:
- Inspect and test sensors for correct resistance.
- Replace the faulty board or component if needed.
- Turn the selector fully to a programming option.
Meaning: Errors in electronic boards, memory issues, or scrambled configuration.
Fix:
- Power cycle the machine.
- If persistent, boards may need a reflash/replacement by a technician.
Meaning: The drum's self-positioning sensor (for inverter models) isn't working correctly.
Fix:
- Sensor or wiring may need replacement; consult a technician.
Meaning: flow valve, turbidity sensor, or load sensor errors.
Fix:
- Check relevant sensors/valves; clean or replace as needed.
Meaning:
- EF0, EF1: Drain system or filter blocked
- EF2: Too much detergent foam
- EF4: Low water pressure
- EF5: Drum is unbalanced
Fix: - Clean filters and run rinse cycle.
- Use correct detergent quantity.
- Redistribute laundry evenly.
Meaning: Voltage or frequency is outside the acceptable range.
Fix:
- Use stable power.
- Surge protectors might help.
- Persistent issues? Ask an electrician or technician.